meh, yes and no. typical auto desk shenanigans. free for personal use.

yeah, freeCAD is kinda crappy compared to even F360

notion is good, but felt so slow. tried it out for a few months, and then did a hybrid approach with obsidian and wound up favoring and then eventually just porting everything over and fully switching to obsidian. been good.

what? I have never heard this about them. is that possibly if you use their sync service?

industrial grating is the worst for this. Feels like you’re just over ground, but a slip up means that sucker is falling 50 m and then into some gnarly machinery

Yeah, use the mix. /s but also kinda not since the box mix is dang good

While that’s true, the actual empirical curve does not have to be smooth. Or gaussian.

Bitet instead. Those wipes are okay occasionally or while traveling

You can inject CAN bus commands if you can sniff what they’re sending. No firmware modification necessary. Not saying it’s a good idea to do so, but it is possible to do so.

I assume the coastal regions have significantly cheaper sushi than Dallas and Denver.

The verb tweet was the only thing they had going for them.